SHIFT PADDLE SWITCH INSPECTION

PROCEDURE


  1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. B0019SAE09
      Text in Illustration
      *a

      Component without harness connected

      (Transmission Shift Switch Assembly LH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Transmission Shift Switch Assembly LH
      Tester Connection Switch Condition Specified Condition
      SDN - ECC "-" shift paddle operated and held (down-shift) Below 2.5 Ω
      "-" shift paddle not operated (down-shift) 1 MΩ or higher

      If the resistance values are not as specified, replace the transmission shift switch assembly LH.

    2. A01WPQCE09
      Text in Illustration
      *a

      Component without harness connected

      (Transmission Shift Switch Assembly RH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Transmission Shift Switch Assembly RH
      Tester Connection Switch Condition Specified Condition
      SUP - ECC "+" shift paddle operated and held (up-shift) Below 2.5 Ω
      "+" shift paddle not operated (up-shift) 1 MΩ or higher

      If the resistance values are not as specified, replace the transmission shift switch assembly RH.

  2. INSPECT NO. 1 SWITCH WIRE


    1. Disconnect the No. 1 switch wire connector from the steering pad switch assembly.

    2. A01WRLZE03
      Text in Illustration
      *a

      No. 1 Switch Wire

      (to Steering Pad Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      z59-3 (SDN) - z59-4 (ECC) "-" shift paddle operated and held (down-shift) Below 2.5 Ω
      "-" shift paddle not operated (down-shift) 1 MΩ or higher
      z59-1 (SUP) - z59-4 (ECC) "+" shift paddle operated and held (up-shift) Below 2.5 Ω
      "+" shift paddle not operated (up-shift) 1 MΩ or higher

      If the resistance value is not as specified, replace the No. 1 switch wire.