AUTOMATIC TRANSMISSION SYSTEM Pattern Select Switch Sport Mode Circuit

DESCRIPTION

The TCM memory contains the programs for the normal and sport shift patterns.

By following the programs corresponding to the signals from the SPORT S/S+ switch (integration control and panel assembly), the park/neutral position switch and other various sensors, the TCM switches the solenoid valves on and off, and controls the transmission gear change operation.

WIRING DIAGRAM

B0019L5E04

PROCEDURE


  1. INSPECT SPORT S/S+ SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)


    1. B0019C2E20
      Text in Illustration
      *a

      Component without harness connected

      (Integration Control and Panel Assembly)

      Remove the integration control and panel assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      8 (P) - 1 (E) SPORT S/S+ switch on Below 1 Ω
      7 (B) - 1 (E) NORMAL switch on Below 1 Ω
      8 (P) - 1 (E) SPORT S/S+ switch off 10 kΩ or higher
      7 (B) - 1 (E) NORMAL switch off 10 kΩ or higher

    NG

    REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - BODY GROUND)


    1. B0019E6E04
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Integration Control and Panel Assembly)

      Disconnect the integration control and panel assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V12-1 (E) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL ASSEMBLY - ECM)


    1. B0018SQE03
      Text in Illustration
      *A for LHD
      *B for RHD
      *a

      Front view of wire harness connector

      (to ECM)

      Disconnect the ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LHD
      Tester Connection Switch Condition Specified Condition
      A38-34 (PWMS) - Body ground SPORT S/S+ switch on Below 1 Ω
      A38-49 (SPCN) - Body ground NORMAL switch on Below 1 Ω
      A38-34 (PWMS) - Body ground SPORT S/S+ switch off 10 kΩ or higher
      A38-49 (SPCN) - Body ground NORMAL switch off 10 kΩ or higher
      for RHD
      Tester Connection Switch Condition Specified Condition
      A87-34 (PWMS) - Body ground SPORT S/S+ switch on Below 1 Ω
      A87-49 (SPCN) - Body ground NORMAL switch on Below 1 Ω
      A87-34 (PWMS) - Body ground SPORT S/S+ switch off 10 kΩ or higher
      A87-49 (SPCN) - Body ground NORMAL switch off 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR