PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.


    1. Install the park/neutral position switch assembly to the manual valve lever shaft.

    2. A01WTO1

      Temporarily install the park/neutral position switch assembly with the 2 bolts.

      Tech Tips

      Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.

    3. Install the lock washer and the nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

    4. Install the No. 1 shift lever bush to the transmission control shaft lever.

    5. Install the bush to the transmission control shaft lever.

    6. A01WRF7

      Temporarily install the transmission control shaft lever.

    7. B0019WRE05

      Turn the transmission control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

    8. Remove the transmission control shaft lever.

    9. B001ASYE04
      Text in Illustration
      *a Neutral Basic line
      *b Groove

      Align the groove with the neutral basic line.

    10. A01WTO1

      Hold the park/neutral position switch assembly in the position described above and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    11. B001AE3E08
      Text in Illustration
      *a Protective Tape

      Using a screwdriver, bend the tabs of the lock washer.

    12. A01WRF7

      Install the transmission control shaft lever with the spring washer and nut.

      Torque:
      16 N*m  { 163 kgf*cm, 12 ft.*lbf }

    13. Connect the switch connector.

  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. B001A3S

      Connect the floor shift gear shifting rod sub-assembly to the transmission control shaft lever with the pin.

    2. Install a new clip.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here

  5. INSTALL NO. 3 FRONT FLOOR HEAT INSULATOR


    1. Install the No. 3 front floor heat insulator with the 4 nuts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  7. INSPECT FOR EXHAUST GAS LEAK