PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  2. REMOVE NO. 3 FRONT FLOOR HEAT INSULATOR


    1. A01WRAA

      Remove the 4 nuts and No. 3 front floor heat insulator.

  3. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

    B001A63

    1. Remove the clip and pin, and disconnect the floor shift gear shifting rod sub-assembly from the transmission control shaft lever.

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. A01WVZP

      Disconnect the switch connector.

    2. A01WRF7

      Remove the nut, spring washer and transmission control shaft lever.

    3. A01WURL

      Remove the bush from the transmission control shaft lever.

    4. A01WTX1

      Remove the No. 1 floor shift bush from the transmission control shaft lever.

    5. A01WR60E07
      Text in Illustration
      *1 Lock Washer
      *2 Lock Nut
      *a Protective Tape

      Using a screwdriver, bend the tabs of the lock washer.

      Tech Tips

      Tape the screwdriver tip before use.

    6. Remove the lock nut and lock washer.

    7. A01WTO1

      Remove the 2 bolts and park/neutral position switch assembly.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.