SHIFT LEVER ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT SHIFT LEVER POSITION


    1. When moving the shift lever from P to R with the engine switch on (IG) and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

    2. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.

    3. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.

      If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.

  2. CHECK SHIFT LOCK OPERATION


    1. Move the shift lever to P.

    2. Turn the engine switch off.

    3. Check that the shift lever cannot be moved from P.

    4. Turn the engine switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.

      If the operation cannot be done as specified, inspect the shift lever assembly and shift lock control unit.

  3. CHECK SHIFT LOCK RELEASE BUTTON OPERATION


    1. When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position.

      If the operation cannot be performed as specified, check the shift lever assembly.

  4. CHECK SHIFT LOCK CONTROL ECU

    A01WU80E39
    Text in Illustration
    *a

    Component with harness connected

    (Shift Lock Control ECU)

    1. Measure the voltage according to the value(s) in the table below.

      Tech Tips

      Do not disconnect the shift lock control ECU connector.

      Standard Voltage
      Tester Connection Condition Specified Condition
      12 (IG) - 3 (E) Engine switch on (IG) 11 to 14 V
      Engine switch off Below 1 V
      6 (STP) - 3 (E) Depress brake pedal 11 to 14 V
      Release brake pedal Below 1 V
    2. A01WU80E40
      Text in Illustration
      *a

      Component with harness connected

      (Shift Lock Control ECU)

      Measure the resistance according to the value(s) in the table below.

      Tech Tips

      Do not disconnect the shift lock control ECU connector.

      Standard Resistance
      Tester Connection Condition Specified Value
      3 (E) - Body ground Always Below 1 Ω
    3. A01WWPDE10
      Text in Illustration
      *a

      Component with harness connected

      (Shift Lock Control ECU)

      Disconnect the shift lock solenoid connector from the shift lock control ECU.

    4. Measure the voltage according to the value(s) in the table below.

      Tech Tips

      Do not disconnect the shift lock control ECU connector.

      Standard Voltage
      Tester Connection Condition Specified Condition
      1 (SLS+) - 2 (SLS-) Engine switch off Below 1 V
      1 (SLS+) - 2 (SLS-) Engine switch on (IG) Below 1 V
      Engine switch on (IG) and brake pedal depressed 11 to 14 V

      If the result is not as specified, replace the shift lever assembly.