MILLIMETER WAVE RADAR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.

Tech Tips


  • Use the same procedures for LHD and RHD vehicles.

  • The procedures listed below are for LHD vehicles.

PROCEDURE


  1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

    Note


    • If the front bumper assembly or radiator grille has been replaced, check that the beam axis change mechanism is at the standard position (centered).

    • Only perform this procedure when the beam axis change mechanism adjustment position is not in the standard position (center).


    1. B0019AUE03
      Text in Illustration
      *a Beam Axis Change Mechanism
      *b Bolt

      Set beam axis to the standard position.


      1. Turn the bolt so that the beam axis change mechanism is positioned as shown in the illustration.

        Specified Condition
        Difference between (A) and (B): 1 mm (0.0394 in.) or less

        Note

        The beam axis change mechanism may be damaged if torque exceeding the specified amount (1.5 N*m{15kgf*cm.13 in.*lbf}) is applied.

    2. Attach the 2 guides.

    3. B001AN0E05
      Text in Illustration
      *a Bolt
      *b Screw

      Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly.

      Torque:
      Bolt
      2.5 N*m  { 25 kgf*cm, 22 in.*lbf }

      Tech Tips

      Tighten the bolts and screws in the order indicated in the illustration.

    4. Connect the connector.

  2. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  3. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. When the millimeter wave radar sensor assembly is replaced, or the No. 1 millimeter wave radar sensor bracket is replaced or removed/installed, adjust the millimeter wave radar sensor assembly.

      Click here