OIL PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. A01WT2PE12
      *a Component without harness connected: (Oil Pressure Sender Gauge)
      *b Test LED

      Disconnect the oil pressure sender gauge connector.

    2. Apply battery positive (+) voltage to the oil pressure sender gauge terminal through a test LED.

    3. Check that the LED does not illuminate when the engine is stopped.

    4. Check that the oil pressure sender gauge operation.

      OK
      Condition Specified Condition
      Engine stopped LED does not illuminate
      Engine is running Number of flashes varies with engine speed

      If the result is not as specified, replace the oil pressure sender gauge assembly.