ENGINE OIL COOLER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  7. DRAIN ENGINE OIL

    Click here

  8. DRAIN ENGINE COOLANT

    Click here

  9. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  10. REMOVE FAN AND GENERATOR V BELT

    Click here

  11. REMOVE OIL FILTER ELEMENT

    Click here

  12. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY

    Click here

  13. DISCONNECT COOLER COMPRESSOR ASSEMBLY

    Click here

  14. REMOVE NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY


    1. Remove the 3 bolts.

    2. B0019GU

      Disconnect the 4 hoses and remove the water by-pass pipe.

  15. REMOVE NO. 1 OIL COOLER BRACKET


    1. B001961

      Remove the 2 nuts and bracket.

    2. Disconnect the ground wire from the cylinder block.

  16. REMOVE OIL FILTER BRACKET


    1. B0019UX

      Remove the 2 bolts, 2 nuts and filter bracket.

    2. B00192X

      Remove the 2 O-rings.

  17. REMOVE OIL COOLER ASSEMBLY


    1. B00192H

      Remove the 5 nuts and oil cooler from the oil filter bracket.

    2. B001AOI

      Remove the 2 O-rings.

  18. REMOVE OIL COOLER SPACER


    1. B0019DK

      Remove the bolt and oil cooler spacer from the oil filter bracket.

    2. B001B0GE01
      *1 Gasket

      Remove the gasket.