OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. B001ARCE01
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    2. B001A82

      Install the oil pressure sender gauge.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    3. B001AOH

      Connect the sender gauge connector.

  2. ADD ENGINE OIL

    Click here

  3. INSPECT FOR OIL LEAK

    Click here

  4. INSPECT ENGINE OIL LEVEL

    Click here

  5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here