EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

    Click here

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

    Click here

  3. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 2 new nuts.

      Torque:
      54 N*m  { 551 kgf*cm, 40 ft.*lbf }

    2. Install the wire harness clamp bracket of the oxygen sensor to the transmission with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    3. Connect the heated oxygen sensor connector.

  4. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    1. Install a new gasket and the front No. 2 exhaust pipe to the exhaust manifold LH with 2 new nuts.

      Torque:
      54 N*m  { 551 kgf*cm, 40 ft.*lbf }

    2. Install the wire harness clamp bracket of the oxygen sensor to the transmission with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    3. Connect the heated oxygen sensor connector.

  5. INSTALL CENTER EXHAUST PIPE ASSEMBLY


    1. Install 2 new gaskets to the front exhaust pipe and front No. 2 exhaust pipe.

    2. Install the center exhaust pipe to the 3 exhaust pipe supports, and then install the 4 bolts.

      Torque:
      48 N*m  { 489 kgf*cm, 35 ft.*lbf }

  6. INSTALL EXHAUST PIPE DAMPER


    1. A01WQN5

      Install the exhaust pipe damper to the tailpipe with the 2 bolts.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

  7. INSTALL TAILPIPE ASSEMBLY


    1. Install the tailpipe to the 2 exhaust pipe supports.

    2. Install a new gasket to the center exhaust pipe.

    3. Connect the tailpipe to the center exhaust pipe.

    4. A01WPWKE09
      *1 Top
      *2 LH Side
      *3 Front
      *4 Gasket

      Attach a new clamp to the tailpipe and center exhaust pipe. Then install the bolt to the clamp.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Tech Tips

      Install the clamp within the angle range shown in the illustration.

  8. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

    Tech Tips

    If an exhaust gas leak has been repaired, perform an inspection following the repair.

    Click here

  9. INSTALL NO. 2 ENGINE UNDER COVER

    Click here