COMMON RAIL INSPECTION

PROCEDURE


  1. INSPECT COMMON RAIL ASSEMBLY RH


    1. Inspect the fuel pressure sensor.


      1. A01WPHIE03
        Text in Illustration
        *a

        Component without harness connected

        (Fuel Pressure Sensor)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 16.4 kΩ or less
        2 - 3 25°C (77°F) 3 kΩ or less

        If the result is not as specified, replace the common rail assembly RH.

  2. INSPECT COMMON RAIL ASSEMBLY LH (w/ DPF)


    1. Inspect the pressure discharge valve.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 0.96 to 1.16 Ω

        If the result is not as specified, replace the common rail assembly LH.