FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    1. Disconnect the cables from the negative (-) main battery and sub-battery terminals.

  3. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  4. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

    Click here

  5. REMOVE AIR DUCT PLUG

    Click here

  6. REMOVE REAR AIR DUCT GUIDE

    Click here

  7. SEPARATE REAR FLOOR MAT ASSEMBLY

    B001AS1

    1. Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.

      Tech Tips

      Fold back the rear floor mat assembly so that the rear No. 7 air duct can be removed.

  8. REMOVE REAR NO. 7 AIR DUCT


    1. B00188L

      Detach the 4 clips and remove the rear No. 7 air duct.

  9. REMOVE REAR FLOOR SERVICE HOLE COVER

    B0018N3

  10. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. B0019G0

      Disconnect the fuel sender gauge connector.

    2. B0018T1

      Remove the 5 screws and fuel sender gauge assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Remove the gasket from the fuel sender gauge assembly.