REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

    Click here

  5. REMOVE REAR CRANKSHAFT OIL SEAL


    1. B0019JEC01
      *1 Rear Crankshaft Oil Seal
      *a Cut Position

      Using a knife, cut off the lip of the rear crankshaft oil seal.

    2. Using a screwdriver, pry out the rear crankshaft oil seal.

      Note

      Be careful not to damage the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.