DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT


    1. B001B3IE12

      Set the V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the bar.

      Note

      Make sure that the V belt is properly set to each pulley.

    3. B0019QAE01
      *1 CORRECT
      *2 INCORRECT

      After installing the belt, check that it fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  5. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  6. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here