CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When removing the No. 2 black out tape LH, No. 6 black out tape LH, upper inner black out tape LH, rear inner black out tape LH, and rear door front window frame moulding LH, heat the vehicle body, No. 2 black out tape LH, No. 6 black out tape LH, upper inner black out tape LH, rear inner black out tape LH, and rear door front window frame moulding LH using a heat light.
| Standard | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Note
Do not heat the vehicle body, No. 2 black out tape LH, No. 6 black out tape LH, upper inner black out tape LH, rear inner black out tape LH, and rear door front window frame moulding LH excessively.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
REMOVE UPPER RADIATOR SUPPORT SEAL
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH
REMOVE REAR DOOR TRIM COVER
REMOVE COURTESY LIGHT ASSEMBLY
REMOVE DOOR ASSIST GRIP COVER LH
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
REMOVE REAR SPEAKER SET
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR DOOR GLASS RUN LH
REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH
REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH
REMOVE REAR DOOR FRAME GARNISH LH
REMOVE REAR DOOR NO. 2 FRAME GARNISH LH
REMOVE REAR DOOR CHECK ASSEMBLY LH
REMOVE REAR DOOR WEATHERSTRIP LH
REMOVE NO. 2 BLACK OUT TAPE LH
Pull back an edge of the No. 2 black out tape LH and pull it parallel to the vehicle body to remove it.
REMOVE NO. 6 BLACK OUT TAPE LH
Pull back an edge of the No. 6black out tape LH and pull it parallel to the vehicle body to remove it.
REMOVE UPPER INNER BLACK OUT TAPE LH
Pull back an edge of the upper inner black out tape LH and pull it parallel to the vehicle body to remove it.
REMOVE REAR INNER BLACK OUT TAPE LH
Pull back an edge of the rear inner black out tape LH and pull it parallel to the vehicle body to remove it.