FRONT DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • When installing the front door rear window frame moulding LH, heat the vehicle body and front door rear window frame moulding LH using a heat light.

Standard
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Front Door Rear Window Frame Moulding LH 20 to 30°C (68 to 86°F)

Note

Do not heat the vehicle body and front door rear window frame moulding LH excessively.

PROCEDURE


  1. INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH


    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the vehicle body surface.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Install a new front door rear window frame moulding LH.


      1. Using a heat light, heat a new front door rear window frame moulding LH and the vehicle body surface.

      2. Remove the peeling paper from the face of the front door rear window frame moulding LH.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. B001893E05
        Text in Illustration
        *a Double-sided Tape

        Attach the clip and double-sided tape to install the front door rear window frame moulding LH.

        Tech Tips

        Press the front door rear window frame moulding LH firmly to install it.

  2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR GLASS RUN LH

    Click here

  4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  5. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  6. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  7. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  8. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  11. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  12. INSTALL FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

    Click here

  13. INSTALL FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

    Click here

  14. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  15. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  17. CHECK SRS WARNING LIGHT

    Click here

  18. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here