FRONT DOOR WINDOW FRAME MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • When removing front door rear window frame moulding LH, heat the vehicle body and front door rear window frame moulding LH using a heat light.

Standard
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Front Door Rear Window Frame Moulding LH 20 to 30°C (68 to 86°F)

Note

Do not heat the vehicle body and front door rear window frame moulding LH excessively.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  6. REMOVE FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

    Click here

  7. REMOVE FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  12. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  13. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  14. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  16. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  17. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

    Click here

  18. REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH


    1. B001893E09
      Text in Illustration
      *a Protective Tape
      *b Double-sided Tape

      Put protective tape around the front door rear window frame moulding LH.

    2. Detach the clip and remove the double-sided tape to remove the front door rear window frame moulding LH.