REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  5. REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH

    Click here

  6. REMOVE REAR DOOR TRIM COVER

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE DOOR ASSIST GRIP COVER LH

    Click here

  9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  11. REMOVE REAR SPEAKER SET

    Click here

  12. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  13. REMOVE REAR DOOR GLASS RUN LH

    Click here

  14. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

    Click here

  15. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  16. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  17. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH


    1. B001AYPE04
      Text in Illustration
      *a Protective Tape

      Put protective tape around the rear door belt moulding assembly LH.

    2. B0019HZ

      Detach the 9 claws and remove the rear door belt moulding assembly LH.