STOP LIGHT CONTROL RELAY(for LHD) INSTALLATION

PROCEDURE

1. INSTALL STOP LIGHT CONTROL RELAY ASSEMBLY

   
   

   1. Attach the clamp to install the stop light control relay assembly.

   2. Connect the connector.

2. INSTALL DOOR CONTROL BATTERY WITH BRACKET

   Click here

3. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

   Click here

4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

5. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH

   Click here

6. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

   Click here

7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

8. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

9. INSTALL INSTRUMENT SIDE PANEL LH

   Click here

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

11. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

12. CHECK SRS WARNING LIGHT

    
    

    1. Check the SRS warning light Click here.