SIDE TURN SIGNAL LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH


    1. Connect the connector.

    2. Install the side turn signal light assembly LH with the 3 screws.

    3. Install the outer mirror cover.


      1. A01WQG7E01
        Text in Illustration
        *1 Rib

        Insert the rib on the outer edge of the cover into the groove of the mirror body.

        Note

        Do not scratch the turn light.

      2. A01WUHME01
        Text in Illustration
        *1 Rib

        Confirm that the cover and mirror body are aligned properly, and then push the outer end of the cover to attach the outer claws.

        Note


        • Make sure that the upper ribs of the cover shown in part A of the illustration are properly attached to the mirror body.

        • Make sure that the ribs of the mirror body shown in part B of the illustration are not protruding from the cover.

      3. A01WUYI

        While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

    4. A01WWTJ

      Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

    5. Check that there is no gap between the cover and mirror body.

      Tech Tips

      If there is a gap between the cover and body, noise will occur during driving.

  2. INSTALL OUTER MIRROR LH

    Click here

  3. INSTALL OUTER REAR VIEW MIRROR LH

    Click here