REAR COMBINATION LIGHT ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    1. A01WWVPC06
      *a

      Component without harness connected:

      (Rear Combination Light Assembly LH)

      Apply battery voltage to the connector and check the light illumination condition.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 4 (TRN)

      Battery negative (-) → 3 (E)

      		 Turn signal light illuminates*A

      Battery positive (+) → 2 (TRN2)

      Battery positive (+) → 4 (TRN)

      Battery negative (-) → 3 (E)

      		 Turn signal light illuminates*B

      Battery positive (+) → 5 (STP)

      Battery negative (-) → 3 (E)

      		 Stop light illuminates

      Battery positive (+) → 6 (TL)

      Battery negative (-) → 3 (E)

      		 Tail light illuminates

      *A: except Sequential Turn Signal Light

      *B: for Sequential Turn Signal Light

      If the result is not as specified, replace the rear combination light assembly LH.

  2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    1. A01WWVPC07
      *a

      Component without harness connected:

      (Rear Combination Light Assembly RH)

      Apply battery voltage to the connector and check the light illumination condition.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 4 (TRN)

      Battery negative (-) → 3 (E)

      		 Turn signal light illuminates*A

      Battery positive (+) → 2 (TRN2)

      Battery positive (+) → 4 (TRN)

      Battery negative (-) → 3 (E)

      		 Turn signal light illuminates*B

      Battery positive (+) → 5 (STP)

      Battery negative (-) → 3 (E)

      		 Stop light illuminates

      Battery positive (+) → 6 (TL)

      Battery negative (-) → 3 (E)

      		 Tail light illuminates

      *A: except Sequential Turn Signal Light

      *B: for Sequential Turn Signal Light

      If the result is not as specified, replace the rear combination light assembly RH.