SFI SYSTEM, Diagnostic DTC:P0630

DTC Code DTC Name
P0630 VIN not Programmed or Mismatch - ECM / PCM

MONITOR DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN with the intelligent tester.

DTC No. DTC Detection Condition Trouble Area
P0630

When either of the following conditions is met (1 trip detection logic):


  • The VIN is not stored in the ECM.

  • The VIN input into the ECM is not accurate.

 ECM

CONFIRMATION DRIVING PATTERN


  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG) and turn the intelligent tester on.

  3. Clear DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  4. Turn the engine switch off and wait for at least 30 seconds.

  5. Turn the engine switch on (IG) and turn the intelligent tester on.

  6. Wait 5 seconds or more.

  7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  8. Read pending DTCs.

    Tech Tips


    • If a pending DTC is output, the system is malfunctioning.

    • If a pending DTC is not output, perform the following procedure.

  9. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

  10. Input the DTC: P0630.

  11. Check the DTC judgment result.

    Tester Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions
    N/A

    • Unable to perform DTC judgment

    • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

CAUTION / NOTICE / HINT

Tech Tips

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    5. Read DTCs.

      Result
      Result Proceed to
      DTC P0630 is output A
      DTC P0630 and other DTCs are output B

      If any DTCs other than P0630 are output, troubleshoot those DTCs first.

      Note

      If P0630 is stored, the VIN must be input to the ECM using the intelligent tester. However, all DTCs are cleared automatically by the intelligent tester when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.


    B

    GO TO DTC CHART Click here

    A

  2. INPUT VIN


    1. Input the VIN Click here.


    NEXT

    END