POWER STEERING OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL POWER STEERING OIL PRESSURE SWITCH


    1. Install a new O-ring to the oil pressure switch.

    2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.

      Note


      • When reusing the oil pressure switch, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the oil pressure switch.

    3. B001A0Y

      Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    4. Connect the oil pressure switch connector.

  2. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH


    1. B0019PB

      Install the sensor with the bolt and nut.

      Torque:
      for bolt
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }
      for nut
      5.6 N*m  { 57 kgf*cm, 56 in.*lbf }

    2. Connect the connector.

  3. INSTALL FAN AND GENERATOR V BELT

    Click here

  4. INSTALL AIR CLEANER ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER HOSE ASSEMBLY

    Click here

  6. ADD POWER STEERING FLUID

  7. BLEED POWER STEERING FLUID

    Click here

  8. INSPECT FOR POWER STEERING FLUID LEAK

  9. INSTALL FRONT FENDER APRON SEAL FRONT RH

    Click here

  10. INSTALL FRONT WHEEL

  11. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

    Click here

  16. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY

    Click here

  17. PERFORM ZERO POINT CALIBRATION OF G SENSOR

    Click here

  18. ADJUST HEADLIGHT ASSEMBLY

    Click here

  19. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  20. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here