POWER STEERING OIL PRESSURE SWITCH REMOVAL

PROCEDURE


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  4. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  5. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  6. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  8. REMOVE AIR CLEANER HOSE ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER ASSEMBLY

    Click here

  10. REMOVE FAN AND GENERATOR V BELT

    Click here

  11. DRAIN POWER STEERING FLUID

  12. REMOVE FRONT WHEEL

  13. REMOVE FRONT FENDER APRON SEAL FRONT RH

    Click here

  14. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH


    1. B0019PB

      Disconnect the connector.

    2. Remove the nut, bolt and sensor.

  15. REMOVE POWER STEERING OIL PRESSURE SWITCH


    1. B001A0Y

      Disconnect the switch connector.

    2. Using a 24 mm deep socket wrench, remove the oil pressure switch.

    3. Remove the O-ring.