KNEE AIRBAG ASSEMBLY(for Front Passenger Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of an LHD vehicle.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  6. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  9. DISCONNECT GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY


    1. A000RPK

      Remove the 4 screws and disconnect the 2 glove compartment door stopper sub-assemblies from the glove compartment door assembly.

  10. REMOVE NO. 2 GLOVE COMPARTMENT PLATE


    1. A000QHD

      Detach the 3 claws to remove the No. 2 glove compartment plate from the glove compartment door assembly.

  11. REMOVE GLOVE COMPARTMENT PANEL


    1. A000OSS

      Detach the 8 claws and glove compartment panel from the glove compartment door assembly.

  12. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    CAUTION:

    When storing the lower No. 2 instrument panel airbag assembly, keep the airbag deployment side facing upward.


    1. A000P8O

      Detach the harness clamp to disconnect the airbag harness from the glove compartment door assembly.

    2. Remove the 4 bolts.

    3. Slightly bend the wall of the glove compartment door, detach the 8 hooks and remove the lower No. 2 instrument panel airbag from the glove compartment door assembly.