COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the autoaway/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the power switch off.

  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  4. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  5. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  10. REMOVE COMBINATION METER ASSEMBLY

    A000O5Z

    1. Remove the 4 screws.

    2. Disconnect the connectors, detach the clamp and remove the combination meter assembly.