HEADUP DISPLAY SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

    2. While using the parts location and circuit diagrams as a reference, inspect areas which can be visually inspected for blown fuses, problems with wire harnesses (open and short circuits), improperly connected connectors, etc.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK CAN COMMUNICATION SYSTEM


    1. Using the GTS, check if the CAN communication system is functioning normally.


      Result
      Result Proceed to
      DTC is not output A
      DTC is output (for LHD) B
      DTC is output (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  4. CHECK FOR DTC*


    1. Check DTCs and freeze frame data.

      Click here


      1. Using the GTS, check the DTCs and freeze frame data.

      2. Record the DTCs and freeze frame data displayed on the screen.

    2. Clear DTCs and freeze frame data.

      Click here


      1. Using the GTS, clear the DTCs and freeze frame data.

    3. Recheck for DTCs.

      Click here


      1. Try to reproduce the problem symptoms based on the recorded DTCs, and then check if the DTCs are output again.

      Result
      Result Proceed to
      No DTCs are output A
      DTCs are output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

    B

    GO TO PROBLEM SYMPTOMS TABLE Click here

    A

  6. PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM


    1. Terminals of ECU.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  7. ADJUST OR REPAIR, REPLACE

    Result
    Proceed to
    NEXT

    NEXT

    END