FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  7. REMOVE FRONT DOOR HOLE COVER

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  11. REMOVE FRONT DOOR TRIM COVER LH

    Click here

  12. REMOVE DOOR FRAME GARNISH LH

    Click here

  13. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  14. REMOVE FRONT DOOR ARMREST SET BRACKET LH

    Click here

  15. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  16. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  17. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  18. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  19. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH

    Click here

  20. REMOVE FRONT DOOR LOCK ASSEMBLY LH


    1. Disconnect the connector.

    2. A000OJ7E01
      Text in Illustration
      *A w/o Double Locking System
      *B w/ Double Locking System

      Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.

    4. Remove the door lock wiring harness seal from the front door lock assembly.

  21. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  22. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here