REAR CROSS TRAFFIC ALERT BUZZER REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system Click here.

  5. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE REAR SEAT HEADREST ASSEMBLY

    Click here

  7. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY

    Click here

  8. REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  10. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  12. REMOVE REAR SEAT SIDE GARNISH RH

    Click here

  13. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  14. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  16. REMOVE BLIND SPOT MONITOR BUZZER


    1. Disconnect the connector.

    2. A000RUJ

      Detach the clamp and remove the blind spot monitor buzzer.