INSTRUMENT PANEL SPEAKER INSPECTION

PROCEDURE


  1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY


    1. Temporarily replace the front No. 2 speaker assembly with a new or normally functioning one.

      OK
      Malfunction disappears.

      Tech Tips


      • Connect the connectors to the front No. 2 speakers.

      • When there is a possibility that either the right or left front No. 2 speaker is defective, inspect by interchanging the right one with the left one.

      • Perform the inspection above on both the LH and RH sides.

  2. INSPECT FRONT NO. 3 SPEAKER ASSEMBLY


    1. w/ Mark Levinson Speaker System:

      Temporarily replace the front No. 2 speaker assembly with a new or normally functioning one.

      OK
      Malfunction disappears.

      Note

      Connect the connectors to the front No. 3 speakers.

    2. w/o Mark Levinson Speaker System:


      1. A000NNWE01
        Text in Illustration
        *a

        Component without harness connected

        (Front No. 3 Speaker Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Always 4 Ω

        If the result is not as specified, replace the front No. 3 speaker assembly.