NOISE FILTER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE REAR SEAT HEADREST ASSEMBLY

    Click here

  7. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY

    Click here

  8. REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  10. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  12. REMOVE REAR SEAT SIDE GARNISH RH

    Click here

  13. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  14. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  15. REMOVE CENTER STOP LIGHT COVER

    Click here

  16. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  17. REMOVE RADIO SETTING CONDENSER

    Note

    If it is necessary to replace the radio setting condenser or terminal cover, both parts must be replaced as they are supplied as a set.


    1. A000RJY

      Using a screwdriver, detach the 8 claws and remove the terminal cover with wire harness from the radio setting condenser.

    2. A000NVJ

      Remove the bolt.

    3. Detach the clamp from the vehicle body and remove the radio setting condenser.

    4. Using a screwdriver, bend back and break off the claw as shown in the illustration.

      A000RKV

    5. Remove the 2 terminal covers from the wire harness.

  18. REMOVE RADIO SETTING CONDENSER

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A000SXH

      Remove the bolt.

    2. Detach the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A000RJ8

      Using a screwdriver, detach the 3 claws and remove the terminal cover with wire harness from the radio setting condenser.

    4. Using a screwdriver, bend back and break off the claw as shown in the illustration.

      A000RVW

    5. Remove the terminal cover from the wire harness.