DYNAMIC REAR STEERING SYSTEM TEST MODE PROCEDURE


  1. TEST MODE

    Tech Tips


    • When the system enters test mode, "DRS Test Mode" is displayed on the multi-information display.


    1. Activate Test Mode (using the GTS).


      1. Turn the power switch off.

      2. Connect the GTS to the DLC3.

      3. Turn the power switch on (IG).

      4. Turn the GTS on.

      5. Enter the following menus: Chassis / DRS / Utility / Check Mode.

    2. End Test Mode (using the GTS).


      1. Turn the power switch off.

      2. Connect the GTS to the DLC3.

      3. Turn the power switch on (IG).

      4. Turn the GTS on.

      5. Switch the system from test mode to normal mode by following the directions on the GTS screen.

    3. Activate Test Mode (using SST check wire).


      1. Turn the power switch off.

      2. A000QT3E01
        Text in Illustration
        *a Front view of DLC3

        Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

        SST
        09843-18040

        Note

        Connect the terminals correctly to avoid a malfunction.

      3. Turn the power switch on (IG).

    4. End Test Mode (using SST check wire).


      1. Turn the power switch off.

      2. A000QT3E01
        Text in Illustration
        *a Front view of DLC3

        Disconnect SST from the DLC3.

        SST
        09843-18040

      3. Turn the power switch on (IG).

        Tech Tips

        If the power switch is turned on (IG) with terminals 12 (TS) and 4 (CG) connected, the system remains in test mode.