POWER STEERING SYSTEM(for 2AR-FSE) DTC CHECK / CLEAR

CHECK FOR DTC (USING THE GTS)
1. Connect the GTS to the DLC3.
2. Turn the power switch on (IG).
3. Turn the GTS on.
4. Enter the following menus: Chassis / EMPS / Trouble Codes.
5. Read the DTCs by following the display on the GTS.
CHECK DTCs (USING SST CHECK WIRE)
1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
  
  SST
  
  09843-18040
  
  Note
  
  Connect the terminals correctly to avoid a malfunction.
2. Turn the power switch on (IG).
3. Read and write down any DTCs indicated by the power steering warning light on the combination meter assembly.
  Tech Tips
  - If normal, a 2 Hz blinking pattern repeats.
  - If there is only 1 DTC, the DTC will be output with a 4 second pause afterward. If there are several DTCs, the DTCs will be output with a 2.5 pause between each code. Once all of the DTCs are output, there is a 4.0 second pause and the DTCs are output again.
  - If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.
4. Disconnect terminals 13 (TC) and 4 (CG) of the DLC3.
  
  Note
  
  If there is a malfunction, check for DTCs again after performing repairs and confirm that no DTCs are output.
CLEAR DTC (USING THE GTS)
1. Connect the GTS to the DLC3.
2. Turn the power switch on (IG).
3. Turn the GTS on.
4. Enter the following menus: Chassis / EMPS / Trouble Codes.
5. Clear the DTCs by following the display on the GTS.
CLEAR DTCs (USING SST CHECK WIRE)
1. Turn the power switch off.
2. Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3, and also terminals 13 (TC) and 4 (CG) of the DLC3.
  
  SST
  
  09843-18040
  
  Note
  
  Connect the terminals correctly to avoid a malfunction.
3. Turn the power switch on (IG).
4. Disconnect and reconnect terminal 13 (TC) of the DLC3 4 times or more within 8 seconds.
5. Check that the power steering warning light blinks a code to indicate normality.
6. Turn the power switch off.
7. Remove SST from the DLC3.