REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR FLEXIBLE HOSE LH


    1. Install the rear flexible hose with a new clip.

      Note

      Make sure the clip is completely pushed in.

    2. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not kink or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting point.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    3. Install a new gasket and connect the rear flexible hose to the rear disc brake cylinder assembly with a union bolt.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Tech Tips

      Insert the flexible hose lock securely into the lock hole in the disc brake cylinder.

  2. BLEED BRAKE LINE

    Click here

  3. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }