REAR BRAKE DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE CYLINDER BOOT


    1. A000MV1E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, remove the cylinder boot.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the rear disc brake piston and rear disc brake cylinder assembly.

  2. REMOVE REAR DISC BRAKE PISTON


    1. Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder assembly.

    2. A000SX0

      Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder assembly.

      CAUTION:

      Do not place your fingers in front of the piston when using compressed air.

      Note

      Be careful not to spatter the brake fluid.

  3. REMOVE PISTON SEAL


    1. A000O5JE04
      Text in Illustration
      *1 Protective tape

      Using a screwdriver, remove the piston seal from the rear disc brake cylinder assembly.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the inner surface of the cylinder or piston seal groove.

  4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

  5. REMOVE REAR DISC BRAKE BLEEDER PLUG