FRONT SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Other than areas where instructions are provided, use the same procedures for the RH and LH sides.

  • The procedures listed below are for LH side.

PROCEDURE


  1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY (SKID CONTROL SENSOR)

    Click here

  2. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT FRONT AXLE HUB RUNOUT

    Click here

  4. INSTALL FRONT DISC


    1. for 17 inch Front Disc Brake:

      Click here

    2. for 18 inch Front Disc Brake:

      Click here

  5. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH


    1. for 17 inch Front Disc Brake:

      Click here

    2. for 18 inch Front Disc Brake:

      Click here

  6. INSTALL SKID CONTROL SENSOR WIRE


    1. Connect the connector.

      Note

      Securely connect the connector.

    2. Install the 2 harness clamps with the 2 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • Make sure the clamp rotation stopper touches the installation position.

      • When installing the clamps, do not twist the wire harness.

    3. Attach the clip.

    4. Install the front fender liner.

    5. B002B4G

      Install the harness clamp with the bolt.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      When installing the clamps, do not twist the wire harness.

    6. Connect the connector.

      Note

      Securely connect the connector.

  7. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  9. INSPECT SPEED SENSOR SIGNAL

    Click here