ELECTRONICALLY CONTROLLED BRAKE SYSTEM Slip Indicator Light Remains ON

DESCRIPTION

The skid control ECU assembly is connected to the combination meter assembly via CAN communication.

If the skid control ECU assembly stores a DTC, the slip indicator light comes on in the combination meter assembly.

The slip indicator light blinks during VSC and/or TRC operation.

When the system fails, the slip indicator light comes on to warn the driver Click here.

WIRING DIAGRAM

B002BZCE02
*1 Combination Meter Assembly
*2 Skid Control ECU Assembly
*3 CAN Communication System

CAUTION / NOTICE / HINT

Note

When replacing the skid control ECU assembly, perform initialization and calibration of the linear solenoid valve Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output (for LHD: See page , for RHD: Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output (for LHD) B
      DTC is output (for RHD) C

    B

    INSPECT CAN COMMUNICATION SYSTEM Click here

    C

    INSPECT CAN COMMUNICATION SYSTEM Click here

    A

  2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED


    1. Check if the skid control ECU assembly connector is securely connected.

      OK
      The connector is securely connected.

    NG

    CONNECT CONNECTOR TO ECU CORRECTLY

    OK

  3. CHECK AUXILIARY BATTERY


    1. Check the auxiliary battery voltage.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      Auxiliary battery Power switch on (IG) 11 to 14 V
      Auxiliary battery Power switch on (READY) 11 to 15.5 V

    NG

    CHARGE OR REPLACE AUXILIARY BATTERY

    OK

  4. INSPECT COMBINATION METER ASSEMBLY


    1. Perform the Active Test of the combination meter assembly (meter CPU) using the GTS Click here.

    2. Check the combination meter assembly.

      OK
      The slip indicator light turns on or off in accordance with the GTS operation.

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Click here.


    OK

    REPLACE SKID CONTROL ECU ASSEMBLY Click here

    NG

    REPLACE COMBINATION METER ASSEMBLY Click here