ELECTRONICALLY CONTROLLED BRAKE SYSTEM, Diagnostic DTC:C1345, C1368

DTC Code DTC Name
C1345 Linear Solenoid Valve Offset Learning undone
C1368 Linear Solenoid Valve Offset

DESCRIPTION

The skid control ECU assembly stores and corrects the individual differences in the stroke sensor, actuator solenoids, and stroke simulator solenoid. Perform initialization of the linear solenoid valve and calibration if any of these parts is replaced.

The skid control ECU assembly receives shift position P signal from the power management control ECU through the CAN communication system.

The DTCs are cleared when the linear valve offset learning results are normal.

DTC Code INF Code DTC Detection Condition Trouble Area
C1345 501 Value of initialization and calibration of the linear solenoid valve for the FR wheel is not stored. Initialization and calibration of the linear solenoid valve undone
↑ 502 Value of initialization and calibration of the linear solenoid valve for the FL wheel is not stored. ↑
↑ 503 Value of initialization and calibration of the linear solenoid valve for the RR wheel is not stored. ↑
↑ 504 Value of initialization and calibration of the linear solenoid valve for the RL wheel is not stored. ↑
C1368 505 Value of initialization and calibration of the linear solenoid valve is not within the brake actuator's standard range.

  • Initialization and calibration of the linear solenoid valve undone

  • Brake actuator assembly

CAUTION / NOTICE / HINT

Note

When replacing the brake actuator assembly, perform initialization and calibration of the linear solenoid valve Click here.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Turn the power switch off.

    3. Turn the power switch on (IG).

    4. Check that the DTCs (electronically controlled brake system and hybrid control system) are recorded.


      • for electronically controlled brake system: Click here

      • for hybrid control system: See page (for 2GR-FXE), Click here (for 2AR-FSE)

      Result
      Result Proceed to
      DTCs (except C1345, C1368 and hybrid control system DTC) are not output A
      Hybrid control system DTC is output (for 2GR-FXE) B
      Hybrid control system DTC is output (for 2AR-FSE) C
      DTCs (except C1345 and/or C1368) are output D

      Tech Tips

      Before carrying out Perform Initialization and Calibration of the Linear Solenoid Valve, C1203/95 will be output.


    B

    INSPECT HYBRID CONTROL SYSTEM Click here

    C

    INSPECT HYBRID CONTROL SYSTEM Click here

    D

    REPAIR CIRCUITS INDICATED BY OUTPUT DTCS Click here

    A

  2. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE


    1. Turn the power switch off.

    2. Perform initialization and calibration of the linear solenoid valve Click here.


    NEXT

  3. RECONFIRM DTC


    1. Turn the power switch off.

    2. Clear the DTCs Click here.

    3. Turn the power switch on (IG).

    4. Check if the same DTC is recorded Click here.

      Result
      Result Proceed to
      DTCs (C1345 and C1368) are not output A
      DTCs (C1345 and/or C1368) are output B

    A

    END

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here