GRILLE SHUTTER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL RADIATOR SHUTTER SUB-ASSEMBLY


    1. Attach the 2 clips to temporary install the radiator shutter.

    2. Connect the connector of the radiator shutter.

    3. Close the radiator shutter sub-assembly.


      1. Connect the GTS to the DLC3 and turn the power switch on (IG).

      2. Enter the following menus: Body Electrical / Grille Shutter / Active Test / Shutter Closing Operation Lock Detection. Then, perform Close or OFF.

        Note

        The radiator shutter sub-assembly cannot be installed if it has not been closed.

      3. Turn the power switch off.

    4. Install the radiator shutter of the 4 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Attach the clamp to install the thermistor.

  2. INSTALL RADIATOR SUPPORT OPENING COVER


    1. Attach the 4 claws to install the radiator support opening cover.

    2. Install the 2 bolts and 4 clips.

  3. INSTALL ENGINE UNDER COVER

    Click here

  4. INSTALL FRONT BUMPER ENERGY ABSORBER

    Click here

  5. INSTALL FRONT BUMPER COVER


    1. for Sport Package:

      Click here

    2. except Sport Package:

      Click here

  6. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  7. INSTALL ENGINE ROOM SIDE COVER

    Click here

  8. CHANGE RADIATOR SHUTTER CONTROL STATE

    Tech Tips

    If the swing grille actuator assembly is replaced with a new one, perform the following procedure.


    1. Drive the vehicle at a speed of 5 km/h (3 mph) or more.

      Tech Tips

      Once the speed signal is received normally, the state of the radiator shutter sub-assembly changes as follows to the normal control state.


      • Radiator shutter sub-assembly is operable

      • Cautions are not displayed

      • DTCs: none

      • Shutter state: open

  9. CHECK RADIATOR SHUTTER

    Click here

  10. ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)


    1. Fill the washer jar with washer fluid.

  11. ADJUST FOG LIGHT AIMING

    Click here

  12. CHECK LEXUS PARKING ASSIST-SENSOR SYSTEM (w/ LEXUS Parking Assist-sensor System)

    Click here