PROCEDURE
REMOVE ENGINE ROOM SIDE COVER
Remove the 4 clips and engine room side cover.
REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 7 clips and cool air intake duct seal.
REMOVE FRONT BUMPER COVER
Remove the 8 screws.
| *a | 90° |
Using a screwdriver, turn the 2 pin hold clips 90° and remove the pin hold clips and screw.
Tech Tips
Use the same procedure for the pin hold clips and screw on the other side.
Remove the 4 clips bolt.
Put protective tape around the front bumper cover.
|
Protective Tape |
Detach the 10 claws and remove the front bumper cover.
Disconnect the 2 fog light connectors.
w/ Headlight Cleaner System:
Disconnect the 2 headlight washer hoses and then drain the washer fluid.
Tech Tips
Use a container to collect the washer fluid.
w/ LEXUS Parking Assist-sensor System:
Disconnect the No. 4 engine room wire.
REMOVE FRONT BUMPER ENERGY ABSORBER
Remove the front bumper energy absorber.
REMOVE THERMISTOR ASSEMBLY
REMOVE ENGINE UNDER COVER (w/ Grille Shutter)
REMOVE RADIATOR SUPPORT OPENING COVER (w/ Grille Shutter)
REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (w/ Grille Shutter)
REMOVE VEHICLE APPROACHING SPEAKER ASSEMBLY
REMOVE FRONT BUMPER REINFORCEMENT
Remove the 6 bolts and front bumper reinforcement.
REMOVE FRONT BUMPER SIDE RETAINER LH
Remove the screw.
Detach the claw and remove the front bumper side retainer LH.
REMOVE FRONT BUMPER SIDE RETAINER RH
Tech Tips
Use the same procedure described for the LH side.
REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Remove the 4 screws and front wheel extension pad LH.
REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Tech Tips
Use the same procedure described for the LH side.