GRILLE SHUTTER SYSTEM, Diagnostic DTC:B14B4

DTC Code DTC Name
B14B4 Lost Communication with Front Grill Shutter ECU LIN

DESCRIPTION

The swing grille actuator assembly receives signals from the air conditioning amplifier assembly via LIN communication.

DTC Code DTC Detection Condition Trouble Area Relevant ECU
B14B4 LIN communication malfunction between the swing grille actuator assembly and air conditioning amplifier assembly.
  • Harness or connector

  • Air conditioning amplifier assembly

  • Swing grille actuator assembly

Air conditioning amplifier assembly

WIRING DIAGRAM

A000O0ME07

CAUTION / NOTICE / HINT

Note


  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • If the swing grille actuator assembly is replaced with a new one, it is necessary to perform "Change Radiator Shutter Control State" Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SWING GRILLE ACTUATOR ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY, BATTERY AND BODY GROUND)


    1. Disconnect the B11 swing grille actuator assembly connector.

    2. Disconnect the N78 air conditioning amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      B11-2 (LIN) - N78-28 (BLIN) Always Below 1 Ω
      B11-4 (GND) - Body ground
      B11-2 (LIN) - Body ground Always 10 kΩ or higher
    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      B11-6 (+B) - Body ground Always 11 to 14 V

    NG
    OK
  2. CHECK SWING GRILLE ACTUATOR ASSEMBLY


    1. Replace the swing grille actuator assembly with a new or normally functioning one Click here.

    2. Check for DTCs Click here.

      OK
      DTC B14B4 output does not occur.

    OK
    NG