REAR DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

   Click here

3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

6. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

7. REMOVE REAR DOOR HOLE COVER

   Click here

8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

   Click here

9. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

   Click here

10. REMOVE REAR DOOR TRIM COVER LH

    Click here

11. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

    Click here

12. REMOVE REAR SIDE CURTAIN ASSEMBLY LH (w/ Rear Sunshade)

    Click here

13. REMOVE REAR DOOR FRAME GARNISH LH

    Click here

14. REMOVE REAR DOOR ARMREST SET BRACKET LH

    Click here

15. REMOVE REAR NO. 2 SPEAKER ASSEMBLY

    Click here

16. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

17. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

    Click here

18. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

    Click here

19. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

20. REMOVE REAR DOOR GLASS RUN LH

    Click here

21. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

    
    

    1. 

       Put protective tape around the rear door belt moulding.

    2. Detach the 4 claws and remove the rear door belt moulding.