TIRE PRESSURE WARNING INITIATOR DRIVER(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  7. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  8. REMOVE FRONT DOOR OPENING TRIM COVER RH

    Click here

  9. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  10. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  11. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  12. REMOVE COWL SIDE JUNCTION BLOCK RH


    1. w/ VGRS System:


      1. A000STR

        Disconnect the 5 connectors.

      2. Using a clip remover, detach the 2 clamps.

    2. w/o VGRS System:


      1. A000SSO

        Disconnect the connector.

      2. Using a clip remover, detach the clamp.

    3. A000S23

      Disconnect the 4 connectors.

    4. A000O6L

      Remove the bolt and nut.

    5. Remove the cowl side junction block RH from the reinforcement.

    6. A000OWQ

      Disconnect the 2 connectors and remove the cowl side junction block RH.

  13. REMOVE ECU INTEGRATION BOX RH


    1. A000PJG

      Disconnect all the connectors.

    2. A000SJ5

      Remove the 2 nuts, bolt and ECU integration box RH.

  14. REMOVE TIRE PRESSURE MONITOR INITIATOR DRIVER


    1. A000QCP

      Detach the 2 claws and remove the tire pressure monitor initiator driver.