TIRE PRESSURE WARNING RECEIVER(for Quarter Pillar) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

    Tech Tips

    The installation location of the tire pressure warning receiver differs depending on the vehicle. For more details about the installation location, refer to the following Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  6. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    1. A000N1J

      Disconnect the connector.

    2. Remove the bolt and tire pressure warning ECU and receiver.