REAR STABILIZER BAR INSTALLATION

PROCEDURE


  1. INSTALL REAR STABILIZER BAR


    1. B002BWIE01

      Temporarily install the bolt (4), and then tighten the bolts in numerical order (1 to 4) to install the stabilizer bar to the rear suspension member.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }

      Note

      The identification mark must be on the right side of the vehicle when installing the rear stabilizer bar.

  2. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

    Click here

  3. INSTALL REAR STABILIZER LINK ASSEMBLY LH


    1. B002C18E01
      Text in Illustration
      *1 Identification Mark

      Install the rear stabilizer link assembly with the 2 nuts.

      Torque:
      for nut A
      89 N*m  { 908 kgf*cm, 66 ft.*lbf }
      for nut B
      70 N*m  { 714 kgf*cm, 52 ft.*lbf }

      Note

      The identification mark must be facing towards the top of the vehicle when installing the rear stabilizer link.

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

  4. INSTALL REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  5. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }