TOE CONTROL LINK REMOVAL

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE TOE CONTROL LINK SUB-ASSEMBLY


    1. Remove the nut on the rear axle carrier side.

    2. Install 2 spacers (SST spacer B) to the toe control link so that there is a space of approximately 1 mm (0.0394 in.) between the link and spacers.

      SST
      09960-20010   ( 09961-02060 )
      A000NC8E04
      Text in Illustration
      *1 Claw *2 Body
      *3 Nut *4 Spacer
      *5 SST (Spacer B) - -
      *a Parallel *b Space of approx. 1 mm
      *c Turn - -

      Note


      • Make sure to install the spacers (SST spacer B) as the axle carrier spacer may shift.

      • As SST may become damaged, make sure the space between the arm and spacers is not less than 1 mm (0.0394 in.).

    3. Using SST, disconnect the toe control link from the rear axle assembly.

      SST
      09960-20010   ( 09961-02010 )

      CAUTION:

      Apply grease molybdenum grease to the threads and end of the SST bolt.

      Note


      • Do not damage the dust cover.

      • As the dust cover may be damaged, adjust SST with the center nut so that the body and claw are parallel.

      • Make sure to tie the string of SST to the vehicle to prevent SST from dropping.

    4. A000SP0E01
      Text in Illustration
      *a Matchmark

      Put matchmarks on the rear No. 2 suspension toe adjust plate and rear suspension member.

    5. Remove the nut, rear suspension toe adjust cam, rear No. 2 suspension toe adjust plate and toe control link.