REAR COIL SPRING INSTALLATION

PROCEDURE


  1. INSTALL REAR UPPER SPRING SEAT


    1. Install the rear upper spring seat to the vehicle with the 3 bolts.

      Torque:
      57 N*m  { 581 kgf*cm, 42 ft.*lbf }

  2. INSTALL REAR COIL SPRING


    1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm.

    2. Install the rear upper coil spring insulator to the rear coil spring.

    3. B002B9OE01
      Text in Illustration
      *a Identification Mark

      Temporarily install the rear coil spring to the rear No. 2 suspension arm.

      Note

      Make sure that the identification mark is positioned towards the lower and outer sides of the vehicle.

    4. B002BWQE01
      Text in Illustration
      *1 Wooden Block
      *2 Jack

      Using a jack and wooden block, raise the vehicle gradually to install the rear No. 2 suspension arm to the rear axle carrier. Then temporarily install the bolt and nut.

      Note


      • Insert the bolt with the threaded end facing the rear of the vehicle.

      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

      • Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      • Make sure to perform this operation with the vehicle kept as low as possible.

    5. B002BQUE01
      Text in Illustration
      *1 Rear Upper Coil Spring Insulator
      *2 Rear Lower Coil Spring Insulator

      Check that the rear upper coil spring insulator and rear lower coil spring insulator are installed as shown in the illustration.

  3. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY

    Click here

  4. INSTALL REAR STABILIZER LINK ASSEMBLY

    Click here

  5. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  6. CONNECT TOE CONTROL LINK SUB-ASSEMBLY (w/o DYNAMIC REAR STEERING)

    Click here

  7. CONNECT REAR STEERING LINK ASSEMBLY (w/ DYNAMIC REAR STEERING)

    Click here

  8. STABILIZE SUSPENSION

    Click here

  9. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

    Click here

  10. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY

    Click here

  11. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY

    Click here

  12. INSTALL REAR SUSPENSION ARM COVER

    Click here

  13. CONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

    Click here

  14. INSTALL REAR WHEEL

    Click here

  15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  16. HEADLIGHT AIMING ADJUSTMENT


    1. for Triple Beam Headlight:

      Click here

    2. for Single Beam Headlight:

      Click here