FRONT UPPER SUSPENSION ARM INSPECTION

PROCEDURE


  1. INSPECT FRONT SUSPENSION UPPER ARM ASSEMBLY


    1. A000SJU

      Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.

    2. Use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn. Take the torque reading on the 5th turn.

      Turning torque
      3.43 N*m (35 kgf*cm, 30 in.*lbf) or less

      If the value is not within the specified range, replace the front suspension upper arm with a new one.

    3. Check the dust boots for cracks or grease leakage.