COMBINATION SWITCH INSPECTION

PROCEDURE


  1. INSPECT COMBINATION SWITCH ASSEMBLY


    1. Remove the combination switch Click here.

    2. A000OQCE01
      Text in Illustration
      *a

      Component without harness connected

      (Combination Switch)

      Measure the resistance according to the values in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (B) - 4 (GND) Pressed Below 10 Ω
      Not pressed 10 kΩ or higher
      7 (P) - 4 (GND) Pressed Below 10 Ω
      Not pressed 10 kΩ or higher

    3. Install the combination switch Click here.