ABSORBER CONTROL ACTUATOR(for Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL ABSORBER CONTROL ACTUATOR


    1. A000Q2KE08
      Text in Illustration
      *a 40°

      Check that the control rod of the front shock absorber is in the position shown in the illustration.

      Note

      If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position before installing the absorber control actuator.

    2. A000OV6E01
      Text in Illustration
      *a 40°

      Install the absorber control actuator to the actuator support bracket.

    3. Turn the actuator clockwise 40° until a click is felt.

      Note


      • Before turning the actuator, make sure to check that the actuator output shaft and control rod are securely connected.

      • Do not turn the actuator more than 40°.

      • Do not drop the absorber control actuator. If it is dropped, replace it with a new one.

  2. INSTALL UPPER SHOCK ABSORBER CAP


    1. Connect the connector.

    2. Install the upper shock absorber cap with the 3 nuts.

      Torque:
      20 N*m  { 200 kgf*cm, 14 ft.*lbf }